The key points for using the road resistance measurement method are as follows
Categories：Product knowledge Date：2024-11-15 Hits：259 View »
It is also a diode with a PN junction.
Categories：Product knowledge Date：2024-11-15 Hits：262 View »
For the frequency doubling effect of diodes, there are frequency doubling relying on varactor diodes and frequency doubling relying on step (i.e. rapid) diodes.
Categories：Product knowledge Date：2024-11-15 Hits：261 View »
Controllable silicon is an electronic component widely used in fields such as electronic devices and computers. It is a semiconductor material with controllable conductive properties and has wide applications in electric power control, motor control, temperature control, and other fields. So how long is the service life of thyristors generally?
Categories：Product knowledge Date：2024-11-15 Hits：268 View »
Excessive temperature can cause the thyristor to frequently burn out.
Categories：Product knowledge Date：2024-11-15 Hits：259 View »
A P1N1P2N2 four layer three terminal device based on silicon single crystal as the basic material.
Categories：Product knowledge Date：2024-11-15 Hits：252 View »
The voltage inspection method is the most effective and commonly used inspection method for checking integrated circuits. As the voltage inspection method is measured in parallel and does not require circuit changes, it is quite convenient to operate.
Categories：Product knowledge Date：2024-11-15 Hits：341 View »
The disassembly method of surface mount integrated circuits is as follows
Categories：Product knowledge Date：2024-11-15 Hits：264 View »
It is a product that replaces voltage stabilizing electronic diodes and is made into a diffusion type or alloy type of silicon. It is a diode with a sudden change in reverse breakdown characteristic curve and is used as a control voltage and standard voltage
Categories：Product knowledge Date：2024-11-14 Hits：266 View »
During normal operation, the substrate of a P-channel enhanced MOS transistor must be connected to the source, and the voltage Vds at the drain center should be negative to ensure that the PN junction between the two P regions and the substrate is reverse biased. At the same time, in order to form a conductive channel near the top surface of the substrate, the voltage Vgs between the gate and the source should also be negative.
Categories：Product knowledge Date：2024-11-14 Hits：253 View »
